To use add the block normaly, pick your file set and of you go.

After that use the definitions below to setup your images one by one.

Thats it, if you want more complex stuff like slides presentation all you need his to create a new template and change the code.

Original plugin and source here:

 Link

Image Options

• data-x = the x co-ordinate of the slide
• data-y = the y co-ordinate of the slide
• data-z = the z co-ordinate of the slide (how far/close it appears to the user)
• data-scale = scales your slide by a factor of this value. A data-scale of 5 would be 5 times the original size of your slide
• data-rotate = rotates your slide by the specified number of degrees
• data-rotate-x = For 3D slides. This is the number of degrees it should be rotated about the x-axis. (Tilt forward/lean back)
• data-rotate-y = For 3D slides. This is the number of degrees it should be rotated about the y-axis (swing in from the left/right)
• data-rotate-z = For 3D slides. This is the number of degrees it should be rotated about the z-axis